|
SES100 SERIES COMPUTER INTERFACE OPTION
The SES100 and SES150 can connect to a PC compatible computer for remote control and data recording, using a standard RS-232 serial port.
With the computer interface you can:
- Monitor and record sensor readings.
- Change the differential (hysteresis) settings for all of the controls such as temperature, light, CO2, etc.
- Override the control pot settings with computer set values, which increases the controllers setting accuracy.
The screen below is the status screen for the SES150 controller. This screen shows the sensor and control pot readings, and also shows the state of the relays.
With the computer interface option you get the software on a single 3.5" disk, RS-232 cable and manual.
System requirements:
PC Compatible computer (80286 or higher recommended) with a 3.5" floppy drive, 512Kb RAM, CGA /EGA/VGA display, RS-232 serial port (9600 baud). A hard disk is recommended if you intend to record data.
|
|
